Finisher 3rd Shift - 10pm-6:30am

CompanyFenner Drives

LocationLancaster, Pennsylvania, United States

TypeOnsite

SAFETY practices MUST be exercised by each operator at all times.
Use safety devices and equipment provided.
Refer to shop manual procedures and types of edge finishing.
Finishers will set rolls on finish table, straighten spirals so they are uniform and connect panels with connecting crimp.
Once table load is set up, confirm “spirals per foot” from the entry on the shop order.
Apply tension and trim spirals.
Square the belt.
Weld edges of belt in accordance with type of edge required.
Inspect belt.
Take belt to shipping department once approved by department supervisor

Your tracker settings

We use cookies and similar methods to recognize visitors and remember their preferences. We also use them to measure ad campaign effectiveness, target ads and analyze site traffic. To learn more about these methods, including how to disable them, view our Cookie Policy or Privacy Policy.

By tapping `Accept`, you consent to the use of these methods by us and third parties. You can always change your tracker preferences by visiting our Cookie Policy.

Discover the best startup and their job positions, all in one place.

Copyright © 2025